JXL Car Subwoofer XS-AW10 (10 Inches) Active Underseat Subwoofer 350 RMS Power 300+ Watts, Ultra Sleek, Shallow subwoofer, high Level Input/Audio – line Input

From the manufacturer

10” Compact Active Under Seat Subwoofer – with 350 watts RMS (600 watts Max Power) Class AB amplifier with external bass controller, High level input with DC Detect (Auto Turn On), Aluminium cone with rubber surround, slim profile enclosure and variable crossover.

General Specifications

10” Aluminium Cone with Rubber Surround350 watts RMS (600 watts Max Power) Class AB amplifierHigh Level input with DC Detect (Auto Turn On) / RCA inputExternal Bass Controller included in packagingFrequency Response Range 20Hz – 150HzPhase Selector 0-180 switch optionVariable Crossover 50-150HzPower Handling – 120 W + 120 WPeak Power – 300W + 300WTHD – <0.4%Sigal to noise ration – >92DBMagnet Diamerter – 120mmImpedeance – 4 ohm

Features:

• Subwoofer: 10” (254mm)

• Integrated Amplier: 350 watts RMS / 600 watts MAX Power

• Amplier type: Class A/B

• Enclosure type: Slim Underseat Form Factor (Sealed)

• Woofer Cone Material: Aluminium with Rubber surround

• Frequency Response: 32-5K Hz

• Tone Controls: Gain, Bass Boost (0, +12dB)

• Signal Input: Low Level (RCA pair), High Level (Left/Right)

• Visual Indicators: POWER/PROTECT

• Crossover Controls: Variable (50-150Hz)

• Phase Select: 0°-180°

• DC Offset: Built in-Auto Turn ON

• Fuse Rating: 25A

• External Remote Controller included in packaging

Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback

installations will require a 15-17 foot RCA cable, while pickup trucks and under-seat installations will

require a 6-12 foot RCA cable. Always use a high quality cable.

NOTE: Do not connect BOTH the high level and low level inputs from your head unit

High Level Input Wiring

The high level input(s) should only be used when the head unit lacks RCA outputs. If the RCA outputs

are not present, connect the speaker outputs from the receiver to the high level input connector of the

ampli􀃶er. Be sure to observe correct polarity to avoid audio phase problems.

NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the same time.

10 Inches Powerfull Subwoofer
Shallow Under Seat Design
RMS Power – 6X9″-Inch Low Profile 200 W
THD – <0.4%
Signal-to-noise Ratio – >90 db
Frequency Eesponse – 20 Hz – 150 Hz
Input Senstivity, high level – 0.9 V
Input Senstivity, low level – 300 mV
Low Pass Filter – 50Hz – 150 Hz
Bass Boost – 0 to +12 db